This data was first used to support the paper: V.K. Maes, S. Minakuchi, N. Chandarana, J. Kratz "Shape change of composite corners due to tooling pressure distribution effects" published in Composites Part A: Applied Science and Manufacturing. 2025: 108924.

This dataset contains greyscale normalised TIF images from X-Ray Computed Tomography (XCT) scanning of a unidirectional carbon fibre epoxy laminate with at total void volume of around 2%. Combinations of scan times, from 30 seconds to 60 minutes, and voxel sizes, from 6 to 50 µm, were investigated for their effect on the porosity measurements. The data were obtained and analysed according to the methods described in the paper "The Effect of X-Ray Computed Tomography Scan Parameters on Porosity Assessment of CFRP Laminates" by P Galvez-Hernandez, R Smith, K Gaska, M Mavrogordato, I Sinclair, and J Kratz, which was published in the Journal of Composite Materials.

This data was obtained and analysed according to the methods described in the paper: "Tracking consolidation of out-of-autoclave prepreg corners using pressure sensors" by VK Maes, A Radhakrishnan, J Hartley, S Sykes, J Kratz published in Composites Part A: Applied Science and Manufacturing. 2022. https://doi.org/10.1016/j.compositesa.2022.107172

Data for JCOMA-20-816

Data is collected during the manufacturing process of composite materials made by RTM. This data was obtained and analysed according to the methods described in the paper by Levy and Kratz, 2018.

This data was obtained and analysed according to the methods described in the paper "Heat transfer simulation of the cure of thermoplastic particle interleaf carbon fibre epoxy prepregs" by T Mesogitis, J Kratz, and A Skordos, published in the Journal of Composite Materials, 2019.